Latest Low Profile Mini Fuse Tap Dual Aps Fuse Holder Includes 15AMP+10AMP Fuse

(1) BRAND NEW LOW PROFILE DUAL MINI FUSE TAP(for use with type APS fuse usually for newer vehicle with low profile blades).
(1) 15AMP LOW PROFILE FUSE(fuse varies from actual picture).
(1) 10AMP LOW PROFILE FUSE(fuse varies from actual picture)

1. Disconnect power source. (turn off engine)
2. Select and remove a fuse from the vehicle fuse box not to exceed 25AMP. (check note on top)
3. Insert new accessory fuse (not to exceed 15 amps at 12 volts) into slot #2.
4. Install the Low-Profile Mini Dual Fuse Tap with just the accessory fuse into the fuse block.
5. Reconnect the power source and test the new accessory for proper operation.
6. If the new accessory does not operate properly, turn the Low-Profile Mini Dual Fuse Tap 180 degrees and reinsert it in the fuse block.
7. Test the new accessory for proper operation.
8. Replace the original fuse in slot #1 and test both accessories for proper operation.